- "Check and rethread the upper thread." appears on the LCD.
- "Connected to PC. Do not disconnect the USB cable." appears on the LCD.
- "In twin needle mode, the needle thread lever cannot be used." appears on the LCD.
- "Lower the buttonhole lever." appears on the LCD.
- "Lower the presser foot lever." appears on the LCD.
- "Not enough available memory to save the pattern. Delete another pattern?" appears on the LCD.
- "OK to automatically lower the presser foot?" appears on the LCD.
- "OK to save the current setting?" appears on the LCD.
- "Raise the buttonhole lever." appears on the LCD.
- "Saving the upgrade file. Do not turn MAIN power to OFF." appears on the LCD.
- "The "Start/Stop" button does not operate with the foot controller attached. Remove the foot controller." appears on the LCD.
- "The bobbin thread is almost empty." appears on the LCD.
- "The bobbin winder safety device has activated. Is the thread tangled?" appears on the LCD.
- "The needle is down. Press the needle position button to raise the needle." appears on the LCD.
- "This function can not be used while the machine is in twin needle mode. Cancel twin needle mode and choose the function again."appears on the LCD.
- "Turn off the power and replace the needle plate." appears on the LCD.
- "Use the presser foot lifter button to lower the presser foot." appears on the LCD.
- "When the speed controller is set to control the zigzag stitch width, the "Start/Stop" button does not operate." appears on theLCD.
- "A malfunction occurred. Turn the machine off, then on again." message appears on the LCD. What does it mean?